With the standard atomizer barely 3/4 of an inch big, airflow around the coil has always been a challenge. Aspire has developed a revolutionary coil design that frees up even more restriction in the airflow.
On a side-by-side comparison, the Aspire Cleito Coil is noticeably longer than most atomizers. That's because Aspire has gotten rid of the static chimney that houses the coil and instead uses the coil head as the chimney itself.
The full-length coil head runs through the center of the Cleito tank from top to base. This effectively improves cross sectional airflow with a minimum 25.5mm airflow allowance.
By removing the need for a static center tube within the tank, the Aspire Cleito eliminates all choke points from coil to drip tip to produce even more airflow every time you take a puff. And combined with a claptonized Kanthal coil, it creates thicker vapor with an expanded flavor profile.
Inside the coil is a Clapton style Kanthal build wrapped with 100% pure organic cotton wick. The Cleito comes with two coil options: 0.4 ohm rated at 40W to 60W and 0.2 ohm rated at 55W to 70W.
All Aspire coil heads that are color coded with a yellow gasket feature Clapton style builds with a Kanthal base wire and Kanthal wrap. These coils provide more surface area compared to standard coil designs – resulting in thicker vapor production with a noticeable increase in flavor.
Around the coil are three large juice flow holes that allow the wick to soak up your favorite liquid.
Just below the heating element are four wide bore holes that allow air to pass through from the air control valve at the bottom of the tank.
How To Replace Your Aspire Cleito Coils/Heads
The atomizer head is replaceable and should be properly maintained to keep flavors tasting fresh. Options include a 0.4 ohm-rated Clapton coil (40W to 60W) and a 0.2 ohm-rated Clapton coil (55W to 70W), or an RTA deck system for building your own custom coil.
The Aspire Cleito RTA Deck System Kit will be available soon! (Learn More Here)
Follow These Steps When Replacing Your Worn Out Coil Head -
- Disassemble your Aspire Cleito Tank by taking apart the top cap, Pyrex glass tube, and tank base.
- Remove the old coil head from the base and screw in a fresh one.
- Put the Pyrex glass tube back on and make sure it fits securely onto the O-ring.
- Refill your tank with a high vg e-liquid and replace the top cap.
Most Note-Worthy Features:
- Revolutionary full-length vertical coil design
- No choke points from coil to drip tip
- Intense flavors
- Rapid vapor delivery
- 25.5mm cross section airflow
- Clapton coil build
- Available in 0.4 ohm (40W to 60W) and 0.2 ohm (55W to 70W) resistances
- 100% pure organic cotton wicks